help needed in dundee-flywheel removal

_adam_19 · 30/07/2010, 10:53

is there anyone in dundee that would kindly give me a hand in getting my flywheel off as i have tried and tried with the puller and still no joy!

Coop500 · 30/07/2010, 11:38

Tried shocking it with a big rubber mallet or somthing when the puller is tightened up??

_adam_19 · 30/07/2010, 11:44

been trying that yea still not budging

Coop500 · 30/07/2010, 19:14

Ahh well that's me fresh outa ideas :P

I'd keep hitting it, maybe apply heat... don't know if this will have any side effects though!

fastmini1380 · 31/07/2010, 00:34

how tight is your puller ? i usualy have a 36" breaker bar with a bit of scaffold tube on the end of it and my 13 stone on the end of that , if that doesnt work then some decent skelps with a big copper mullet thru the starter hole turn a bit then more hammering . be carefull not to hammer the sh*t out of the flywheel if its going back on as it can be knocked out of balance giving clutch judder after its all put together

_adam_19 · 31/07/2010, 11:33

i have a big bar and big pole on the end . . . then me jumping up and down on it and hitting it . . . i think ill take it to a garage i know

J666HOL · 01/08/2010, 03:54

If your near barrys garage take it in hel have a look for you, x

_adam_19 · 01/08/2010, 12:13

where is barrys garage? x

J666HOL · 01/08/2010, 12:57

Its Fyffes car services on Fyffe street at the bottom of benvie road... If you go tell him i sent you in, x

**Boab** · 01/08/2010, 15:39

Have you taken the flywheel crankshaft key plate out